Wiretapping laws don’t cover who you can take photos of.

Yeah but this whole post is about resin prints, which cannot be acetone smoothed.

if you turn off end to end encryption

isn’t that the main reason to use it though, privacy?

No, the reason clear 3d prints are cloudy is because layer lines cause scattering, which makes it appear cloudy. Coating the surface with a clear epoxy fills in the tiny gaps that causes light to scatter, improving the optical clarity.

Is the part in the middle not 3D printed? It says Formlabs Form 3.

Every 100 years but not every 400 years! Isn’t it fun?

Small correction, it’s every fourth year except every hundreth year except every 400th year. I’m assuming the misconception comes from the last time it was a 100th also being a 1000th (2000) but the next time a leap year will end in 00 is 2400

Than 35? No, you’re not going to build a new printer from scratch for less than $35, especially if you don’t have another printer to print parts.

Buy a hotend, figure out what you did wrong previously, and fix your machine.

They probably bought it from someone who previously had rented it out.

Either the fees didn’t jump straight to $930 from $110 or the person didn’t do due diligence in reviewing the condo’s budget before they bought.

Dude, that looks rough as hell compared to any resin print. I don’t get why some people just have to cope so hard over this, resin is just better for detail, it’s not a comment on your print skills or whatever.