• 0 Posts
  • 38 Comments
Joined 1 year ago
cake
Cake day: July 25th, 2023

help-circle


  • May not help at all, but one thing I noticed with my prints was that if I removed it before the bed cooled, it would often warp. I’ve since left it until it cools to room temperature and have got much better results.

    Does it warp and lift from the base plate during the print, or does it stay stuck down? The former could be because of lack of adhesive and a raft/brim/glue may help, but the latter may just be lifting it off too early.



  • On places like Bluesky, most articles, videos or news content I’d share would have more to do with how much I trust the person posting or sharing it than with its main body of content. I figure that someone I value has read it, and so I skip it, because reading it would feel like work and I have to deal with enough of that as it is.

    Not to mention, “You won’t believe this one cool thing!” type headlines (like this one) are classic clickbaiting, and nobody wants to read a 10 page article that’s basically just advertising.


  • Thanks man, that’s some solid advice even if my work is a lot more pliable for security. I’d also say that compliance and risk are very good motivation, if you can nmap the servers and SSH in with default credentials and zero alarms during, that could cost millions in data loss, compliance fines, and recovery efforts. Show them solid figures and it’s a hell of a motivator.












  • While it’s a pretty good vpn all round that’s super easy to set and forget, I’ve been having issues the last ~6 months in Australia with the CIDR ranges getting blocked by Google, Reddit, and the like. It’s annoying to have it run fine for a few days, then suddenly have every second thing I do needing to solve a captcha for it.

    Try the freemium tier for a while and see if it works for you - I may be wrong and you’ll run a whole month with nothing, but never hurts to verify.